Disposal [10/2015 - ]: Procedure
- DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY (Shock Absorber Type A)
- Position the front shock absorber assembly on a flat, level surface with the piston rod fully extended. Using a drill, make a hole in the cylinder between (A) and (B) shown in the illustration to discharge the gas inside.WARNING:
Always use proper safety equipment and be careful when drilling because shards of metal may fly about.
HINT:
The gas is colorless, odorless and non-poisonous.
- Position the front shock absorber assembly on a flat, level surface with the piston rod fully extended. Using a drill, make a hole in the cylinder between (A) and (B) shown in the illustration to discharge the gas inside.
- DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY (Shock Absorber Type B)
- Position the front shock absorber assembly on a flat, level surface with the piston rod fully extended. Using a drill, make a hole in the cylinder between (A) and (B) shown in the illustration to discharge the gas inside.WARNING:
Always use proper safety equipment and be careful when drilling because shards of metal may fly about.
HINT:
The gas is colorless, odorless and non-poisonous.
- Position the front shock absorber assembly on a flat, level surface with the piston rod fully extended. Using a drill, make a hole in the cylinder between (A) and (B) shown in the illustration to discharge the gas inside.