DTC C1A50: Brake System [10/2014 - 10/2015]: Procedure

1. Check for electronically controlled brake system DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

   OK

   Electronically controlled brake system DTCs are not output.

Result: 

NG 

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2014 - 10/2015] )

Result: 

OK 

See step  2

1. Replace the brake booster with master cylinder assembly (skid control ECU) (Refer to COMPONENTS [10/2014 - ] ).

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
5. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - 10/2015] ).
6. Drive the vehicle.
7. Recheck for DTCs.

   OK

   DTC C1A50 is not output.

Result: 

OK 

END (BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY WAS DEFECTIVE) 

Result: 

NG 

REPLACE DRIVING SUPPORT ECU ASSEMBLY 

(Refer to COMPONENTS [10/2014 - 10/2015] )