DTC C1A10: Front Radar Sensor [10/2014 - 10/2015]: Procedure

1. Replace the millimeter wave radar sensor assembly (Refer to COMPONENTS [10/2014 - 10/2015] ).

Result: 

NEXT 

See step  2

1. Adjust the millimeter wave radar sensor assembly (Refer to ADJUSTMENT [10/2014 - 10/2015] ).

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
5. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - 10/2015] ).
6. Recheck for DTCs.

   OK

   DTC C1A10 is not output.

Result: 

OK 

END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE) 

Result: 

NG 

REPLACE DRIVING SUPPORT ECU ASSEMBLY 

(Refer to COMPONENTS [10/2014 - 10/2015] )