LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Control System - Diagnostic Codes - (Hybrid) (6 Of 8) >> Hybrid Control System >> DTC P0C73-776: Motor Electronics Coolant Pump "A" Control Performance [10/2014 - 10/2015] >> Confirmation Driving Pattern

Confirmation Driving Pattern

GTY571755Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 30 seconds or more.
  5. Turn the power switch on (IG) and check that there are no abnormalities (abnormal sounds, coolant leaks, DTC output, etc).
  6. Turn the power switch on (READY) and turn the Techstream on. [A]
  7. Wait for 2 minutes or more.
  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [B]
  9. Read the current DTCs.

    HINT: 

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
  10. Check that permanent DTCs are cleared.
  11. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.
scientia non olet · About LEMON Manuals