DTC P1606-308: Collision has been detected or Collision Sensor Connection (Open); DTC P1606-317: Collision has been detected or Collision Sensor Connection (Open) [10/2015 - ]: Procedure

1. Check the vehicle condition.

   Result

   Result	Proceed to
   The vehicle is not damaged.	A
   The vehicle is damaged.	B

Result: 

B 

REPAIR VEHICLE 

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Result

   Result	Proceed to
   Other than below.	A
   P0A1D is output at the same time.	B

5. Turn the power switch off.

Result: 

B 

GO TO DTC CHART (P0A1D) 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ] )

Result: 

A 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Access the freeze frame data of DTC P1606 and read the INF code.

   Result

   Result	Proceed to
   INF code 308 is output.	A
   INF code 317 is output.	B

5. Turn the power switch off.

Result: 

A 

CHECK AIRBAG SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

B 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check for DTCs.

   Result

   Result	Proceed to
   P3107-213, P3107-214, U0151-763, U0110-160 or U0110-657 is output at the same time.	NEXT

5. Turn the power switch off.

NEXT 

GO TO DTC CHART (HYBRID CONTROL SYSTEM) 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ] )