DTC P0A0F-204: Engine Failed to Start; DTC P0A0F-205: Engine Failed to Start; DTC P0A0F-206: Engine Failed to Start; DTC P0A0F-524: Engine Failed to Start; DTC P0A0F-525: Engine Failed to Start [10/2014 - 10/2015]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
4. Check for DTCs.

   Result

   Result	Proceed to
   SFI system DTCs are not output.	A
   SFI system DTCs are output.	B

   HINT: 

   If P0A0F-204, 205, 206, 524, or 525 is output even though the ECM has not detected a malfunction, there is a malfunction in the power management control ECU.

5. Turn the power switch off.

A 

REPLACE POWER MANAGEMENT CONTROL ECU 

(Refer to COMPONENTS [10/2014 - 10/2015] )

B 

GO TO DTC CHART (SFI SYSTEM) 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2014 - 10/2015] )