IG Power Source Circuit [10/2015 - ]: Procedure

1. Disconnect the D62 air conditioning amplifier assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D62-1 (IG+) - Body ground	Power switch off	Below 1 V
   D62-1 (IG+) - Body ground	Power switch on (IG)	11 to 14 V

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D62-14 (GND) - Body ground	Always	Below 1 Ω

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR