DTC C1AA9: Front Camera Module Beam Axis Not Adjusted [10/2015 - ]: Procedure
WARNING: This page is about a different car, the 2018 Toyota Avalon, 2017 Toyota Avalon, and 2016 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [10/2015 - ]
- Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Turn the power switch on (IG) and wait 2 seconds or more.
- Check for DTCs.
Refer to DTC CHECK / CLEAR [10/2015 - ]
Result
Result Proceed to DTC C1AA9 is not output A DTC C1AA9 is output B
Result:
A
END
Result:
B
See step 2
- PERFORM FORWARD RECOGNITION CAMERA LEARNING
- Perform Forward Recognition Camera Learning.
Refer to ADJUSTMENT [10/2015 - ]
Result:
NEXT
See step 3
- Perform Forward Recognition Camera Learning.
- CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [10/2015 - ]
- Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Turn the power switch on (IG) and wait 2 seconds or more.
- Check for DTCs.
Refer to DTC CHECK / CLEAR [10/2015 - ]
Result
Result Proceed to DTC C1AA9 is not output A DTC C1AA9 is output B
Result:
A
END
Result:
B
REPLACE FORWARD RECOGNITION CAMERA. Refer to COMPONENTS [10/2015 - ]