DTC C1AA3: Vehicle Speed Sensor Circuit [10/2015 - ]: Procedure

HINT: 

Forward recognition camera system DTC C1AA3 may be stored due to a malfunction in the electronically controlled brake system. Therefore it is necessary to check for and troubleshoot electronically controlled brake system DTCs first.

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
5. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2014 - ]

   Result

   Result	Proceed to
   Electronically controlled brake system DTCs are not output	A
   Electronically controlled brake system DTCs are output	B

Result: 

B 

GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] 

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
5. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

6. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Turn the power switch on (IG) and wait 7 seconds or more.
7. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Result

   Result	Proceed to
   DTC C1AA3 is not output	A
   DTC C1AA3 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] 

Result: 

B 

See step  3

1. Replace the forward recognition camera.

   Refer to REMOVAL [10/2015 - ]

2. Perform Forward Recognition Camera Learning.

   Refer to ADJUSTMENT [10/2015 - ]

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
5. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

6. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Turn the power switch on (IG) and wait 7 seconds or more.
7. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Result

   Result	Proceed to
   DTC C1AA3 is not output	A
   DTC C1AA3 is output	B

Result: 

A 

END (FORWARD RECOGNITION CAMERA WAS DEFECTIVE) 

Result: 

B 

REPLACE SKID CONTROL ECU (BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY). Refer to  COMPONENTS [10/2014 - ]