How To Proceed With Troubleshooting [10/2015 - ]: Procedure

Result: 

NEXT 

See step  2

1. Measure the auxiliary battery voltage with the power switch off.

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

Result: 

NEXT 

See step  3

1. Using the Techstream, check if the CAN communication system is functioning normally.

   HINT: 

   Refer to CAN Bus Check in CAN Communication System.

   Refer to DIAGNOSIS SYSTEM [10/2015 - ]

   OK

   CAN communication system is functioning normally.

Result: 

NG 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] 

Result: 

OK 

See step  4

HINT: 

Refer to DTC Check / Clear.

Refer to DTC CHECK / CLEAR [10/2015 - ] 

1. Check for DTCs and note any codes that are output.
2. Clear the DTCs.
3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ]  

Result: 

A 

See step  5

HINT: 

Refer to Problem Symptoms Table.

Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] 

Result

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU

   Refer to TERMINALS OF ECU [10/2015 - ] 

2. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [10/2015 - ] 

Result: 

NEXT 

See step  7

Result: 

NEXT 

See step  8

Result: 

NEXT 

END