DTC P2610: ECM / PCM Internal Engine Off Timer Performance [10/2014 - ]: Procedure

1. Replace the ECM (Refer to REMOVAL [10/2014 - ] ).

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
5. Turn the power switch off and wait for at least 30 seconds.
6. Turn the power switch on (IG).
7. Turn the Techstream on.
8. Put the engine in inspection mode (maintenance mode) (Refer to INSPECTION MODE PROCEDURE [10/2014 - ] ).
9. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
10. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
11. If no pending DTC is output, the repair has been successfully completed.

Result: 

NEXT 

END