DTC P0116: Engine Coolant Temperature Circuit Range / Performance Problem [06/2017 - ]: Procedure
- Check Any Other DTCs Output (In Addition To DTC P0116)
- Connect The Techstream To The Dlc3.
- Turn The Power Switch On (Ig).
- Turn The Techstream On.
- Enter The Following Menus: Powertrain / Engine And ECT / Trouble Codes.
- Read The DTCs.Result
Result Proceed To DTC P0116 Is Output A DTC P0116 And Other DTCs Are Output B Hint:
If Any DTCs Other Than P0116 Are Output, Troubleshoot Those DTCs First.
Result:
B
Go To DTC Chart
(Refer to Diagnostic Trouble Code Chart [06/2017 - ] )
Result:
A
See Step 2
- Inspect Water Inlet With Thermostat Sub-Assembly
- Inspect The Thermostat (Thermostat Operating Temperature) (Refer to Inspection [10/2014 - ]
).
Hint:
Perform "Inspection After Repair" After Replacing The Engine Coolant Temperature Sensor (Refer to Initialization [10/2014 - ] ).
Result:
Ok
Replace Engine Coolant Temperature Sensor
(Refer to Removal [10/2014 - ] )
Result:
Ng
Replace Water Inlet With Thermostat Sub-Assembly
(Refer to Removal [10/2014 - ] )
- Inspect The Thermostat (Thermostat Operating Temperature) (Refer to Inspection [10/2014 - ]
).