Confirmation Driving Pattern
- Connect The Techstream To The Dlc3.
- Turn The Power Switch On (Ig) And Turn The Techstream On.
- Enter The Following Menus: Powertrain / Engine And ECT / Data List / Primary / Coolant Temp.
- Check That The Engine Coolant Temperature Is 60°C (140°F) Or Less.
- Clear The DTCs (Even If No DTCs Are Stored, Perform The Clear DTC Procedure).
- Turn The Power Switch Off And Wait For At Least 30 Seconds.
- Turn The Power Switch On (Ig) And Turn The Techstream On [A].
- Put The Engine In Inspection Mode (Maintenance Mode) (Refer to Inspection Mode Procedure [10/2014 - ] ).
- Start The Engine And Idle It For 5 Minutes Or More [B].
Hint:
If The Engine Coolant Temperature Does Not Change By 5°C (9°F) Or Higher, The Engine Coolant Temperature Sensor Is Malfunctioning. It Is Not Necessary To Continue This Procedure.
- Enter The Following Menus: Powertrain / Engine And ECT / Trouble Codes [C].
- Read The Pending DTCs.
Hint:
- If A Pending DTC Is Output, The System Is Malfunctioning.
- If A Pending DTC Is Not Output, Perform The Following Procedure.
- Enter The Following Menus: Powertrain / Engine And ECT / Utility / All Readiness.
- Input The DTC: P0116.
- Check The DTC Judgment Result.
Techstream Display Description Normal - DTC Judgment Completed
- System Normal
Abnormal - DTC Judgment Completed
- System Abnormal
Incomplete - DTC Judgment Not Completed
- Perform Driving Pattern After Confirming DTC Enabling Conditions
N/A - Unable To Perform DTC Judgment
- Number Of DTCs Which Do Not Fulfill DTC Preconditions Has Reached ECU Memory Limit
Hint:
- If The Judgment Result Shows Normal, The System Is Normal.
- If The Judgment Result Shows Abnormal, The System Has A Malfunction.
- If The Judgment Result Shows Incomplete Or N/A, Perform Steps [D] And [E].
- With The Engine Running, Drive The Vehicle At 40 Km/H (25 Mph) Or More For A Total Of 5 Minutes Or More [D].WARNING:
When Performing The Confirmation Driving Pattern, Obey All Speed Limits And Traffic Laws.
Hint:
- In The Event Of The Drive Pattern Being Interrupted (Possibly Due To Factors Such As Traffic Conditions), The Drive Pattern Can Be Resumed.
- If The Engine Stops, Further Depress The Accelerator Pedal To Restart The Engine.
- Check The DTC Judgment Result Again [E].
Hint:
If The Judgment Result Shows Incomplete Or N/A, Perform Steps [D] And [E] Again.
- If No Pending DTC Is Output, Perform A Universal Trip And Check For Permanent DTCs (Refer to DTC Check / Clear [10/2014 - ]
).
Hint:
- If A Permanent DTC Is Output, The System Is Malfunctioning.
- If No Permanent DTC Is Output, The System Is Normal.