How To Proceed With Troubleshooting [10/2015 - ]: Procedure

Result: 

NEXT 

See step  2

Result: 

NEXT 

See step  3

1. Inspect auxiliary battery voltage with the power switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

2. Check for blown fuses, open or shorted wire harnesses, improperly connected connectors and other problems in areas that can be visually inspected.

Result: 

NEXT 

See step  4

1. Check if CAN communication DTCs are output.

   w/ Central Gateway ECU: Refer to DIAGNOSIS SYSTEM [10/2015 - ]

   w/o Central Gateway ECU: Refer to DIAGNOSIS SYSTEM [10/2015 - ]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

w/ Central Gateway ECU: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]

w/o Central Gateway ECU: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]

Result: 

A 

See step  5

1. Check for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2014 - ] )

Result: 

A 

See step  6

Result: 

NEXT 

See step  7

Result: 

NEXT 

See step  8

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] ).

Result: 

NEXT 

See step  9

Result: 

NEXT 

See step  10

Result: 

NEXT 

See step  11

Result: 

NEXT 

END