Customize Parameters [10/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Customize Setting / Warning.
5. Select the setting by referring to the table below.
   NOTE:

   • Be sure to record the current value before customizing.
   WARNING
   
   

   Tester Display	Default	Content	Setting	Relevant ECU
   Key Remind Volume	Large	Function to change the volume of the key remind warning buzzer	Large, Medium, Small	Combination meter assembly
   Key Remind Sound	Normal	Function to change the cycle of the key remind warning buzzer	Normal, Slow, Fast	Combination meter assembly
   Lane Change Flashing Times Setting	3	Function to change the lane change flashing times	OFF, 3, 4, 5, 6, 7	Combination meter assembly

HINT: 

• Press and hold the DISP switch to enter an item.
• Briefly press the DISP switch to select an item.

1. Turn the power switch on (IG).
2. Select the following menu: Settings
3. Select the setting by referring to the table below.
   NOTE:

   • Be sure to record the current value before customizing.
   SETTINGS
   
   

   Display	Default	Content	Setting	Relevant ECU
   Digital Speed	OFF	Function to change the digital speedometer on the display	OFF or ON	Combination meter assembly
   Turn-by-Turn*1	ON	Function to change the navigation display	OFF or ON	Combination meter assembly
   Units*2	English	Function to change the units on the display	English or Metric	Combination meter assembly
   EV Indicator*3	ON	Function to activate/deactivate the EV indicator light	OFF or ON	Combination meter assembly

   • *1: w/ Navigation System
   • *2: w/o Navigation System
   • *3: w/ Shift Paddle Switch
4. Press and hold the DISP switch.
5. Return to the item selection screen.