Wireless Charger Power Source Circuit [10/2014 - ]: Procedure

1. Disconnect the D118 upper console panel sub-assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D118-5 (PGND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D118-1 (ACC) - D118-5 (PGND)	Power switch on (ACC)	11 to 14 V

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR