Main Switch Signal Circuit [10/2014 - ]: Procedure

1. Remove the mobile wireless charger switch (Refer to REMOVAL [10/2014 - ] ).
2. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   11 (+B) - 8 (D)	Mobile wireless charger switch is on (not protruding)	Below 1 Ω
   	Mobile wireless charger switch is off (protruding)	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Mobile Wireless Charger Switch)

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [10/2014 - ] )

Result: 

NG 

REPLACE MOBILE WIRELESS CHARGER SWITCH 

(Refer to REMOVAL [10/2014 - ] )