LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Axles (Service Information) (Hybrid) >> Rear Axle Hub >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY 
    1. Install the rear axle hub and bearing assembly and parking brake assembly to the rear axle carrier sub-assembly with the 4 bolts.

      Torque: 60 N*m (612 kgf*cm, 44 ft.*lbf) 

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS 

    See step  7

  3. INSPECT REAR AXLE HUB RUNOUT 

    See step  8

  4. CONNECT SKID CONTROL SENSOR WIRE 

    Refer to PROCEDURE - Step 4

  5. INSTALL REAR DISC 

    Refer to PROCEDURE - Step 1

  6. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG 

    Refer to PROCEDURE - Step 2

  7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY 

    See step  11

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Connect the cable to the negative (-) auxiliary battery terminal (Refer to PROCEDURE - Step 2 ).
    2. Connect the reservoir level switch connector.
    3. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
  9. ADJUST PARKING BRAKE 

    (Refer to ADJUSTMENT [10/2014 - ] )

  10. INSTALL REAR WHEEL 

    Torque: 103 N*m (1049 kgf*cm, 76 ft.*lbf) 

  11. CHECK FOR SPEED SENSOR SIGNAL 

    (Refer to TEST MODE PROCEDURE [10/2014 - 10/2015] or TEST MODE PROCEDURE [10/2015 - ] )

scientia non olet · About LEMON Manuals