LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronically Controlled Brake System - Diagnostic Codes (2 Of 2) & Symptom Tests - (Hybrid) >> Electronically Controlled Brake System >> Symptom Tests >> TRAC OFF Indicator Light does not Come ON [10/2015 - ] >> Procedure

TRAC OFF Indicator Light does not Come ON [10/2015 - ]: Procedure

  1. CHECK CAN COMMUNICATION SYSTEM 
    1. Check if CAN communication system DTCs are output.

      w/ Central Gateway ECU: Refer to DIAGNOSIS SYSTEM [10/2015 - ]

      w/o Central Gateway ECU: Refer to DIAGNOSIS SYSTEM [10/2015 - ]

      Result

      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    Result: 

    INSPECT CAN COMMUNICATION SYSTEM 

    w/ Central Gateway ECU: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]

    w/o Central Gateway ECU: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]

    Result: 

    See step  2

  2. PERFORM ACTIVE TEST USING TECHSTREAM (MULTI-INFORMATION DISPLAY (TRAC OFF MESSAGE)) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Select the Active Test on the Techstream (Refer to DATA LIST / ACTIVE TEST [10/2015 - ] ).
      ABS/VSC/TRAC

      Tester Display Test Part Control Range Diagnostic Note
      TRC(TRAC) OFF Indicator Light Multi-information display (TRAC OFF message) Display (message) ON/OFF Observe combination meter assembly
    4. Check that the multi-information display (TRAC OFF message) on the combination meter assembly turns on or off in accordance with Techstream operation.

      OK

      The multi-information display (TRAC OFF message) turns on or off in accordance with Techstream operation.

      HINT: 

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the parts (Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] ).

    Result: 

    OK 

    REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY 

    (Refer to REMOVAL [10/2014 - ] )

    Result: 

    NG 

    See step  3

  3. INSPECT COMBINATION METER ASSEMBLY 
    1. Turn the power switch off.
    2. Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream (Refer to DATA LIST / ACTIVE TEST [10/2015 - ] ).
    3. Check the combination meter assembly.

      OK

      The multi-information display turns on or off in accordance with Techstream operation.

      HINT: 

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step (Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] ).

    Result: 

    OK 

    REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY 

    (Refer to REMOVAL [10/2014 - ] )

    Result: 

    NG 

    INSPECT METER / GAUGE SYSTEM 

    (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )