Slip Indicator Light does not Come ON [10/2014 - 10/2015]: Procedure

1. Check if CAN communication system DTCs are output (Refer to DIAGNOSIS SYSTEM [10/2014 - 10/2015] ).

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

INSPECT CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the Active Test on the Techstream (Refer to DATA LIST / ACTIVE TEST [10/2014 - 10/2015] ).
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter assembly

4. Select the Data List on the Techstream (Refer to DATA LIST / ACTIVE TEST [10/2014 - 10/2015] ).
   ABS/VSC/TRAC
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Slip Indicator Light	Slip indicator light / ON or OFF	ON: Indicator light on OFF: Indicator light off	-

5. Check the operating condition of the slip indicator light when operating it using the Techstream.

   Result

   Result	Proceed to
   Slip indicator light in the Data List does not change using the Active Test.	A
   Slip indicator light in the Data List turns ON/OFF using the Active Test.	B

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the parts (Refer to PROBLEM SYMPTOMS TABLE [10/2014 - 10/2015] ).

Result: 

A 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY 

(Refer to REMOVAL [10/2014 - ] )

Result: 

B 

See step  3

1. Turn the power switch off.
2. Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream (Refer to DATA LIST / ACTIVE TEST [10/2014 - 10/2015] ).
3. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step (Refer to PROBLEM SYMPTOMS TABLE [10/2014 - 10/2015] ).

Result: 

OK 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY 

(Refer to REMOVAL [10/2014 - ] )

Result: 

NG 

INSPECT METER / GAUGE SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] )