LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake (Service Information) (Hybrid) >> Parking Brake Cable >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL NO. 2 PARKING BRAKE CABLE CLAMP 
    1. Install a new No. 2 parking brake cable clamp to the No. 3 parking brake cable assembly.
  2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY 
    1. Install the No. 3 parking brake cable assembly with the 4 bolts and nut.
      GTY541655Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Bolt (A) 

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

      Bolt (B) and Nut 

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

    2. Install the No. 3 parking brake cable assembly with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

    3. Install the clip to the No. 3 parking brake cable assembly.
  3. INSTALL NO. 2 FLOOR UNDER COVER (for LH Side) 

    Refer to PROCEDURE - Step 10

  4. INSTALL NO. 1 FLOOR UNDER COVER (for RH Side) 

    Refer to PROCEDURE - Step 11

  5. INSTALL PARKING BRAKE SHOE LEVER 

    (See step  6)

  6. INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR 
    1. Install the front No. 2 floor heat insulator with the 3 nuts.

      Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf) 

  7. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 

    (Refer to INSTALLATION [10/2014 - ] )

  8. INSTALL NO. 4 PARKING BRAKE CABLE ASSEMBLY 
    1. Install the No. 4 parking brake cable assembly to the parking brake equalizer.
      GTY543477Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 No. 4 Parking Brake Cable Assembly
      *2 Rubber Boot
      *3 Parking Brake Equalizer
    2. Slide the parking brake equalizer and rubber boot as shown in the illustration.
      NOTE:

      Make sure that the rubber boot is securely inserted into the groove of the No. 4 parking brake cable assembly.

    3. Connect the No. 3 parking brake cable assembly to the parking brake equalizer.
      GTY598929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Parking Brake Equalizer
      *2 No. 2 Parking Brake Cable Assembly
      *3 No. 3 Parking Brake Cable Assembly
      *4 No. 4 Parking Brake Cable Assembly
    4. Connect the No. 2 parking brake cable assembly to the parking brake equalizer.
  9. INSTALL NO. 4 CROSS MEMBER FLOOR REINFORCEMENT SUB-ASSEMBLY 
    1. Install the No. 4 cross member floor reinforcement sub-assembly with the 8 bolts.

      Torque: 19 N*m (189 kgf*cm, 14 ft.*lbf) 

    2. Install the floor carpet.
  10. INSTALL FLOOR CARPET HOOK 

    Refer to PROCEDURE - Step 17 and PROCEDURE - Step 17

  11. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET (w/ Front Center Speaker) 

    for 9 Speakers: (Refer to PROCEDURE - Step 4 )

    for 11 Speakers: (Refer to PROCEDURE - Step 8 )

  12. INSTALL AUDIO AMPLIFIER COVER (w/ Front Center Speaker) 

    Refer to PROCEDURE - Step 9

  13. INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BACK-UP BATTERY (w/ Manual (SOS) Switch) 

    Refer to PROCEDURE - Step 4

  14. INSTALL AUDIO AMPLIFIER COVER (w/ Manual (SOS) Switch) 

    Refer to PROCEDURE - Step 5

  15. INSTALL FRONT SEAT ASSEMBLY LH 

    (Refer to INSTALLATION [10/2014 - ] )

  16. INSTALL FRONT SEAT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  17. INSTALL CENTER PILLAR LOWER GARNISH LH 

    Refer to PROCEDURE - Step 27 . Refer to PROCEDURE - Step 29

  18. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH 

    Refer to PROCEDURE - Step 6 and PROCEDURE - Step 6

  19. INSTALL LAP BELT OUTER ANCHOR COVER (for LH Side) 

    Refer to PROCEDURE - Step 7 and PROCEDURE - Step 7

  20. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 30 . Refer to PROCEDURE - Step 32

  21. INSTALL REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 31 . Refer to PROCEDURE - Step 33

  22. INSTALL CENTER PILLAR LOWER GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  23. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  24. INSTALL LAP BELT OUTER ANCHOR COVER (for RH Side) 

    HINT: 

    Use the same procedure as for the LH side.

  25. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH 

    Refer to PROCEDURE - Step 40 . Refer to PROCEDURE - Step 42

  26. INSTALL REAR DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

  27. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY 
    1. Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
    2. Install the clip to the No. 1 parking brake cable assembly.
    3. Temporarily install the adjusting nut.
    4. Bend the parking brake pedal claw.
      GTY315845Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  28. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY 

    (Refer to INSTALLATION [10/2014 - 10/2015]  or INSTALLATION [10/2015 - ] )

scientia non olet · About LEMON Manuals