LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Front) - Service Information - (Hybrid) >> Front Brake >> Disassembly [10/2014 - ] >> Procedure

Disassembly [10/2014 - ]: Procedure

  1. REMOVE FRONT DISC BRAKE PISTON 
    1. Place a piece of cloth between the front disc brake piston and front disc brake cylinder assembly.
    2. Apply compressed air to remove the front disc brake piston from the front disc brake cylinder assembly.
      GTY320234Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      WARNING:

      Do not place your fingers in front of the front disc brake piston when using compressed air.

      NOTE:

      Do not allow any brake fluid to spatter.

  2. REMOVE CYLINDER BOOT 
    1. Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the front disc brake cylinder.
      GTY582770Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Protective Tape
      NOTE:

      Be careful not to damage the front disc brake cylinder.

  3. REMOVE PISTON SEAL 
    1. Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the front disc brake cylinder.
      GTY590854Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Protective Tape
      NOTE:

      Do not damage the inner surface or piston seal groove of the front disc brake cylinder.

  4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP 
  5. REMOVE FRONT DISC BRAKE BLEEDER PLUG 
scientia non olet · About LEMON Manuals