LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System (Service Information) (Hybrid) >> Skid Control Buzzer >> Removal [10/2014 - 10/2015] >> Procedure

Removal [10/2014 - 10/2015]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Refer to PRECAUTION [10/2014 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    (Refer to REMOVAL [10/2014 - ] )

  3. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 1

  4. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 4

  5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 5

  6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 11

  7. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 12

  8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 13

  9. REMOVE LOWER NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 14

  10. REMOVE SKID CONTROL BUZZER ASSEMBLY 
    1. Disconnect the connector from the skid control buzzer assembly.
      GTY378889Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clamp to remove the skid control buzzer assembly.
      NOTE:

      Do not use the dropped skid control buzzer assembly.

scientia non olet · About LEMON Manuals