Inspection [10/2014 - ]: Procedure
- INSPECT CURTAIN SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 4 Curtain switch assembly pressed and held Below 1 Ω 1 - 4 Curtain switch assembly not pushed 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Curtain Switch Assembly)If the result is not as specified, replace the curtain switch assembly.
- Measure the resistance according to the value(s) in the table below.