DTC B2784: Antenna Coil Open / Short [10/2014 - 10/2015]: Procedure
- CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - POWER SWITCH)
- Disconnect the D110 certification ECU (smart key ECU assembly) connector.
- Disconnect the D46 power switch connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition D110-13 (CODE) - D46-8 (CODE) Always Below 1 Ω D110-3 (TXCT) - D46-7 (TXCT) Always Below 1 Ω D110-9 (VC5) - D46-10 (VC5) Always Below 1 Ω D110-6 (AGND) - D46-6 (AGND) Always Below 1 Ω D110-13 (CODE) or D46-8 (CODE) - Body ground Always 10 kΩ or higher D110-3 (TXCT) or D46-7 (TXCT) - Body ground Always 10 kΩ or higher D110-9 (VC5) or D46-10 (VC5) - Body ground Always 10 kΩ or higher D110-6 (AGND) or D46-6 (AGND) - Body ground Always 10 kΩ or higher
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- REPLACE POWER SWITCH
- Temporarily replace the power switch with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
Result:
NEXT
See step 3
- CLEAR DTC
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - 10/2015] ).
Result:
NEXT
See step 4
- CHECK FOR DTC
- Check for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - 10/2015]
).
HINT:
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
OK
DTC B2784 is not output.
Result:
OK
END (POWER SWITCH WAS DEFECTIVE)
Result:
NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(Refer to REMOVAL [10/2014 - ] )
- Check for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - 10/2015]
).