LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Window Motors & Regulators >> Windows / Glass (Service Information) (Hybrid) >> Rear Power Window Switch >> Inspection [10/2014 - ] >> Procedure

Inspection [10/2014 - ]: Procedure

  1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Door) 
    1. Check the switch function.
      GTY568212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        6 (UP) - 1 (GND) Auto up or up position Below 1 Ω
        7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω
        8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω
        6 (UP) - 1 (GND) Off 10 kΩ or higher
        7 (DOWN) - 1 (GND) Off 10 kΩ or higher
        8 (AUTO) - 1 (GND) Off 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Rear Power Window Regulator Switch Assembly (for LH Door))

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

    2. Check that the LED illuminates.
      GTY568208Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Apply auxiliary battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK

        Measurement Condition Specified Condition
        Auxiliary battery positive (+) → 4 (LED)
        Auxiliary battery negative (-) → 1 (GND)        		 LED illuminates
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Rear Power Window Regulator Switch Assembly (for LH Door))
        *b LED

        If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).

  2. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Door) 
    1. Check the switch function.
      GTY568212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        6 (UP) - 1 (GND) Auto up or up position Below 1 Ω
        7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω
        8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω
        6 (UP) - 1 (GND) Off 10 kΩ or higher
        7 (DOWN) - 1 (GND) Off 10 kΩ or higher
        8 (AUTO) - 1 (GND) Off 10 kΩ or higher
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Rear Power Window Regulator Switch Assembly (for RH Door))

        If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).

    2. Check that the LED illuminates.
      GTY568208Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Apply auxiliary battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

        OK

        Measurement Condition Specified Condition
        Auxiliary battery positive (+) → 4 (LED)
        Auxiliary battery negative (-) → 1 (GND)        		 LED illuminates
        TEXT IN ILLUSTRATION

        *a Component without harness connected
        (Rear Power Window Regulator Switch Assembly (for RH Door))
        *b LED

        If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).

scientia non olet · About LEMON Manuals