Inspection [10/2014 - ]: Procedure
- INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
- Check the switch function.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 6 (UP) - 1 (GND) Auto up or up position Below 1 Ω 7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω 8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω 6 (UP) - 1 (GND) Off 10 kΩ or higher 7 (DOWN) - 1 (GND) Off 10 kΩ or higher 8 (AUTO) - 1 (GND) Off 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Power Window Regulator Switch Assembly)If the result is not as specified, replace the power window regulator switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Check that the LED illuminates.
- Apply auxiliary battery voltage to the power window regulator switch assembly and check that the LED illuminates.
OK
Measurement Condition Specified Condition Auxiliary battery positive (+) → 4 (LED)
Auxiliary battery negative (-) → 1 (GND)LED illuminates TEXT IN ILLUSTRATION*a Component without harness connected
(Power Window Regulator Switch Assembly)*b LED If the result is not as specified, replace the power window regulator switch assembly.
- Apply auxiliary battery voltage to the power window regulator switch assembly and check that the LED illuminates.
- Check the switch function.