Caution / Notice / Hint

NOTE:

The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 10/2015] or HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] ). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
If the power window regulator motor assembly (for rear RH door) has been replaced with a new one, initialize the power window control system (Refer to INITIALIZATION [10/2014 - ] ).
Check that power window system customize setting "RR Window Auto Up" is set to "Avail" before performing the following procedure (Refer to CUSTOMIZE PARAMETERS [10/2014 - ] ).