LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Seats (Service Information) (Hybrid) >> Seat Variable Cushion Switch >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL NO. 2 SEAT WIRE 
    1. Connect the connector to install the No. 2 seat wire to the seat variable cushion switch.
  2. INSTALL SEAT VARIABLE CUSHION SWITCH 
    1. Install the seat variable cushion switch to the front seat cushion shield with the 2 screws.

      Torque: 0.6 N*m (6 kgf*cm, 5 in.*lbf) 

    2. Engage the clamp.
  3. INSTALL FRONT SEAT CUSHION SHIELD 

    See step  38 See step  38

  4. CONNECT FRONT SEATBACK BOARD SUB-ASSEMBLY 

    See step  45 See step  45

  5. INSTALL FRONT SEAT ASSEMBLY 

    Refer to INSTALLATION [10/2014 - ] 

scientia non olet · About LEMON Manuals