Inspection [10/2014 - ]: Procedure
- INSPECT SEAT MEMORY SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 SET switch pressed Below 1 Ω SET switch not pressed 10 kΩ or higher 1 - 4 M1 switch pressed Below 1 Ω M1 switch not pressed 10 kΩ or higher 1 - 3 M2 switch pressed Below 1 Ω M2 switch not pressed 10 kΩ or higher TEXT IN ILLUSTRATION*1 M1 Switch *2 M2 Switch *3 SET Switch *a Component without harness connected
(Seat Memory Switch)If the result is not as specified, replace the seat memory switch.
- Measure the resistance according to the value(s) in the table below.