Inspection [10/2014 - ]: Procedure
- INSPECT REFRESHING SEAT SWITCH TEXT IN ILLUSTRATION
*a Component without harness connected
(Refreshing Seat Switch)- Check the refreshing seat switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
W/ CLIMATE CONTROL SEAT SYSTEMTester Connection Condition Specified Condition 4 - 6 Always 4 to 6 kΩ 3 - 6 Refreshing seat switch (for LH) on (Vol: max)
(heater position)3.92 to 5.88 kΩ Refreshing seat switch (for LH) on (Vol: max)
(blower position)80 to 120 Ω 1 - 6 Refreshing seat switch (for RH) on (Vol: max)
(heater position)3.92 to 5.88 kΩ Refreshing seat switch (for RH) on (Vol: max)
(blower position)80 to 120 Ω W/O CLIMATE CONTROL SEAT SYSTEMTester Connection Condition Specified Condition 3 - 4 Refreshing seat switch (for LH) off 2.56 to 3.84 kΩ Refreshing seat switch (for LH) on (Vol: max) 256 to 384 Ω 1 - 6 Refreshing seat switch (for RH) off 2.56 to 3.84 kΩ Refreshing seat switch (for RH) on (Vol: max) 256 to 384 Ω If the result is not as specified, replace the refreshing seat switch.
- Measure the resistance according to the value(s) in the table below.
- Check operation of the refreshing seat switch indicator.
- Apply auxiliary battery voltage and check operation of the switch as shown in the table below.
OK
W/ CLIMATE CONTROL SEAT SYSTEMConnection Condition Specified Condition Auxiliary battery positive (+) → Terminal 7
Auxiliary battery negative (-) → Terminal 5Always Illumination comes on Auxiliary battery positive (+) → Terminal 2
Auxiliary battery negative (-) → Terminal 8Always Indicator comes on
(for LH)Auxiliary battery positive (+) → Terminal 2
Auxiliary battery negative (-) → Terminal 9Always Indicator comes on
(for RH)W/O CLIMATE CONTROL SEAT SYSTEMConnection Condition Specified Condition Auxiliary battery positive (+) → Terminal 7
Auxiliary battery negative (-) → Terminal 5Always Illumination comes on Auxiliary battery positive (+) → Terminal 2
Auxiliary battery negative (-) → Terminal 10Refreshing seat switch (for LH) on Indicator comes on
(for LH)Refreshing seat switch (for RH) on Indicator comes on
(for RH)If the result is not as specified, replace the refreshing seat switch.
- Apply auxiliary battery voltage and check operation of the switch as shown in the table below.
- Check the refreshing seat switch.