Inspection [10/2014 - ]: Procedure

1. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	Down switch pressed	Below 1 Ω
   3 - 5
   1 - 5	Up switch pressed
   2 - 3
   2 - 6	Hold switch pressed
   4 - 5
   2 - 4	Release switch pressed
   5 - 6
   1 - 2	Off
   2 - 3
   2 - 4
   2 - 6

   TEXT IN ILLUSTRATION
   
   

   *1	Up Switch
   *2	Down Switch
   *3	Hold Switch
   *4	Release Switch
   *a	Component without harness connected (Front Lumbar Power Seat Switch (for Driver))

   If the result is not as specified, replace the front lumbar power seat switch (for Driver).

1. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	Hold switch pressed	Below 1 Ω
   3 - 5
   1 - 5	Release switch pressed
   2 - 3
   2 - 6	Up switch pressed
   4 - 5
   2 - 4	Down switch pressed
   5 - 6
   1 - 2	Off
   2 - 3
   2 - 4
   2 - 6

   TEXT IN ILLUSTRATION
   
   

   *1	Up Switch
   *2	Down Switch
   *3	Hold Switch
   *4	Release Switch
   *a	Component without harness connected (Front Lumbar Power Seat Switch (for Driver))

   If the result is not as specified, replace the front lumbar power seat switch (for Driver).

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Resistance

If the result is not as specified, replace the front lumbar power seat switch (for front passenger).