LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> Power Seat Switch (W/O Memory) - Service Information - (Hybrid) >> POWER SEAT SWITCH (w/o Seat Position Memory System) >> Inspection [10/2014 - ] >> Procedure

Inspection [10/2014 - ]: Procedure

  1. INSPECT FRONT POWER SEAT SWITCH LH 
    1. Measure the resistance according to the value(s) in the table below.
      GTY321440Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      SLIDE SWITCH

      Tester Connection Condition Specified Condition
      5 - 8 Slide switch pressed
      (Front)      		 Below 1 Ω
      2 - 11
      2 - 12
      5 - 11 Off
      5 - 12
      2 - 11
      2 - 12
      5 - 11 Slide switch pressed
      (Rear)
      5 - 12
      2 - 8
      FRONT VERTICAL SWITCH

      Tester Connection Condition Specified Condition
      1 - 8 Front vertical switch pressed
      (Up)      		 Below 1 Ω
      6 - 11
      6 - 12
      1 - 11 Off
      1 - 12
      6 - 11
      6 - 12
      1 - 11 Front vertical switch pressed
      (Down)
      1 - 12
      6 - 8
      LIFTER SWITCH

      Tester Connection Condition Specified Condition
      3 - 8 Lifter switch pressed
      (Up)      		 Below 1 Ω
      4 - 11
      4 - 12
      3 - 11 Off
      3 - 12
      4 - 11
      4 - 12
      3 - 11 Lifter switch pressed
      (Down)
      3 - 12
      4 - 8
      RECLINING SWITCH

      Tester Connection Condition Specified Condition
      10 - 1 Reclining switch pressed
      (Front)      		 Below 1 Ω
      10 - 6
      10 - 8
      9 - 11
      9 - 12
      10 - 11 Off
      10 - 12
      9 - 11
      9 - 12
      10 - 11 Reclining switch pressed
      (Rear)
      10 - 12
      9 - 3
      9 - 4
      9 - 8
      TEXT IN ILLUSTRATION

      *1 Front Vertical Switch
      *2 Slide Switch
      *3 Lifter Switch
      *4 Reclining Switch
      *a Component without harness connected
      (Front Power Seat Switch LH)

      If the result is not as specified, replace the front power seat switch LH.

  2. INSPECT FRONT POWER SEAT SWITCH RH (w/ Climate Control Seat System) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY366982Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      SLIDE SWITCH

      Tester Connection Condition Specified Condition
      2 - 13 Slide switch pressed
      (Front)      		 Below 1 Ω
      2 - 14
      5 - 9
      5 - 10
      2 - 9 Off
      2 - 10
      5 - 9
      5 - 10
      2 - 9 Slide switch pressed
      (Rear)
      2 - 10
      5 - 13
      5 - 14
      FRONT VERTICAL SWITCH

      Tester Connection Condition Specified Condition
      6 - 13 Front vertical switch pressed
      (Up)      		 Below 1 Ω
      6 - 14
      1 - 9
      1 - 10
      6 - 9 Off
      6 - 10
      1 - 9
      1 - 10
      6 - 9 Front vertical switch pressed
      (Down)
      6 - 10
      1 - 13
      1 - 14
      LIFTER SWITCH

      Tester Connection Condition Specified Condition
      4 - 13 Lifter switch pressed
      (Up)      		 Below 1 Ω
      4 - 14
      3 - 9
      3 - 10
      4 - 9 Off
      4 - 10
      3 - 9
      3 - 10
      4 - 9 Lifter switch pressed
      (Down)
      4 - 10
      3 - 13
      3 - 14
      RECLINING SWITCH

      Tester Connection Condition Specified Condition
      11 - 1 Reclining switch pressed
      (Front)      		 Below 1 Ω
      11 - 6
      11 - 13
      11 - 14
      12 - 9
      12 - 10
      11 - 9 Off
      11 - 10
      12 - 9
      12 - 10
      11 - 9 Reclining switch pressed
      (Rear)
      11 - 10
      12 - 3
      12 - 4
      12 - 13
      12 - 14
      TEXT IN ILLUSTRATION

      *1 Front Vertical Switch
      *2 Slide Switch
      *3 Lifter Switch
      *4 Reclining Switch
      *a Component without harness connected
      (Front Power Seat Switch RH)

      If the result is not as specified, replace the front power seat switch RH.

  3. INSPECT FRONT POWER SEAT SWITCH RH (w/o Climate Control Seat System) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY579345Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      SLIDE SWITCH

      Tester Connection Condition Specified Condition
      2 - 13 Slide switch pressed
      (Front)      		 Below 1 Ω
      5 - 10
      2 - 10 Off
      5 - 10
      2 - 10 Slide switch pressed
      (Rear)
      5 - 13
      RECLINING SWITCH

      Tester Connection Condition Specified Condition
      11 - 13 Reclining switch pressed
      (Front)      		 Below 1 Ω
      12 - 10
      11 - 10 Off
      12 - 10
      11 - 10 Reclining switch pressed
      (Rear)
      12 - 13
      TEXT IN ILLUSTRATION

      *1 Slide Switch
      *2 Reclining Switch
      *a Component without harness connected
      (Front Power Seat Switch RH)

      If the result is not as specified, replace the front power seat switch RH.

scientia non olet · About LEMON Manuals