Inspection [10/2014 - ]: Procedure
- INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY
- Connect a positive (+) lead from the auxiliary battery to terminal 2 and a negative (-) lead to terminal 1.
- Check that the No. 1 interior illumination light assembly comes on.
OK
No. 1 interior illumination light assembly comes on.
TEXT IN ILLUSTRATION*a Component without harness connected
(No. 1 Interior Illumination Light Assembly)If the result is not as specified, replace the No. 1 interior illumination light assembly.
- Connect a positive (+) lead from the auxiliary battery to terminal 2 and a negative (-) lead to terminal 1.