LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System - Diagnostic Codes & Symptom Tests - (Hybrid) >> Navigation System >> DTC B1532: LVDS Signal Malfunction (from Extension Module) [10/2014 - ] >> Procedure

DTC B1532: LVDS Signal Malfunction (from Extension Module) [10/2014 - ]: Procedure

  1. CHECK NAVIGATION WIRE NO. 1 (STEREO COMPONENT TUNER ASSEMBLY POWER SOURCE) 
    1. Disconnect the a2 stereo component tuner assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      a2-8 (GND2) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      a2-4 (+B2) - a2-8 (GND2) Power switch off 11 to 14 V
      a2-3 (ACC2) - a2-8 (GND2) Power switch on (ACC) 11 to 14 V

    Result: 

    NG 

    See step  4

    Result: 

    OK 

    See step  2

  2. REPLACE NAVIGATION WIRE NO. 1 
    1. Replace the navigation wire with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
    2. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
    3. Recheck for DTCs and check that no DTCs are output.

      OK

      No DTCs are output.

    Result: 

    OK 

    END 

    Result: 

    NG 

    See step  3

  3. REPLACE STEREO COMPONENT TUNER ASSEMBLY 
    1. Replace the stereo component tuner assembly with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
    2. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
    3. Recheck for DTCs and check that no DTCs are output.

      OK

      No DTCs are output.

    Result: 

    OK 

    END 

    Result: 

    NG 

    REPLACE NAVIGATION ECU SUB-ASSEMBLY 

    (Refer to REMOVAL [10/2014 - ] )

  4. CHECK NAVIGATION WIRE NO. 1 
    1. Disconnect the a1 navigation ECU sub-assembly connector.
    2. Disconnect the a2 stereo component tuner assembly connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:

      Tester Connection Condition Specified Condition
      a1-4 (+B2) - a2-4 (+B2) Always Below 1 Ω
      a1-3 (ACC2) - a2-3 (ACC2) Always Below 1 Ω
      a1-8 (GND2) - a2-8 (GND2) Always Below 1 Ω
      a1-4 (+B2) - Body ground Always 10 kΩ or higher
      a1-3 (ACC2) - Body ground Always 10 kΩ or higher
      a1-8 (GND2) - Body ground Always 10 kΩ or higher

    Result: 

    OK 

    REPLACE NAVIGATION ECU SUB-ASSEMBLY 

    (Refer to REMOVAL [10/2014 - ] )

    Result: 

    NG 

    REPLACE NAVIGATION WIRE NO. 1 

    (Refer to REMOVAL [10/2014 - ] )