DTC B15FE: XM Tuner Antenna Disconnected; DTC B15FF: XM Tuner Antenna Short [10/2014 - ]: Procedure
- REPLACE ANTENNA CORD SUB-ASSEMBLY
- Replace the antenna cord sub-assembly with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
Result:
OK
END
Result:
NG
See step 2
- REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
- Replace the No. 2 antenna cord sub-assembly with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
- Proceed to the next step based on the inspection result.
Result
Result Proceed to OK A NG (w/o Manual (SOS) Switch) B NG (w/ Manual (SOS) Switch) C
Result:
A
END
Result:
C
See step 5
Result:
B
See step 3
- REPLACE HARNESS AND CONNECTOR (NO. 2 ANTENNA CORD SUB-ASSEMBLY - SATELLITE RADIO ANTENNA ASSEMBLY)
- Replace the harness and connector with a new or known good one.
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
Result:
OK
END
Result:
NG
See step 4
- REPLACE SATELLITE RADIO ANTENNA ASSEMBLY
- Replace the satellite radio antenna assembly with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
Result:
OK
END
Result:
NG
REPLACE STEREO COMPONENT TUNER ASSEMBLY
(Refer to REMOVAL [10/2014 - ] )
- REPLACE HARNESS AND CONNECTOR (NO. 2 ANTENNA CORD SUB-ASSEMBLY - TELEPHONE ANTENNA ASSEMBLY)
- Replace the harness and connector with a new or known good one.
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
Result:
OK
END
Result:
NG
See step 6
- REPLACE TELEPHONE ANTENNA ASSEMBLY
- Replace the telephone antenna assembly with a new or known good one (Refer to REMOVAL [10/2014 - ] ).
- Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
- Recheck for DTCs and check that no DTCs are output.
OK
No DTCs are output.
Result:
OK
END
Result:
NG
REPLACE STEREO COMPONENT TUNER ASSEMBLY
(Refer to REMOVAL [10/2014 - ] )