DTC B1585: USB Device Malfunction [10/2014 - ]: Procedure

REPLACE USB DEVICE OR "iPod"
1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
2. Turn the power switch off.
  HINT:
  
  When this DTC has been stored, it is necessary to turn the power switch off to make it possible for the vehicle to recognize a new device when it is connected.
3. Turn the power switch on (ACC).
4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
  HINT:
  - If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
  - Refer to System Description for compatible formats and versions (Refer to SYSTEM DESCRIPTION [10/2014 - 10/2015] or SYSTEM DESCRIPTION [10/2015 - ] ).
Result:

NEXT

See step 2
CHECK DTC
1. Clear the DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).
2. Recheck for DTCs and check that no DTCs are output.
  OK
  
  No DTCs are output.
Result:

OK

END (USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE)

Result:

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

(Refer to REMOVAL [10/2014 - ] )