How To Proceed With Troubleshooting [10/2015 - ]: Procedure

Result: 

NEXT 

See step  2

Result: 

NEXT 

See step  3

1. Measure the auxiliary battery voltage with the power switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

Result: 

NEXT 

See step  4

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to DIAGNOSIS SYSTEM [10/2015 - ]

   Result

   Result	Proceed to
   CAN communication system DTC is not output.	A
   CAN communication system DTC is output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

A 

See step  5

1. Check for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ] ).

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC is output.	B

Result: 

B 

See step  8

Result: 

A 

See step  6

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table.	A
   Fault is listed in Problem Symptoms Table.	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [10/2015 - ] ).
2. Terminals of ECU (Refer to TERMINALS OF ECU [10/2015 - ] ).

Result: 

NEXT 

See step  8

Result: 

NEXT 

See step  9

Result: 

NEXT 

END