Customize Parameters [10/2014 - ]: Procedure
- CUSTOMIZE AUTOMATIC HIGH BEAM SYSTEM
HINT:
The following item can be customized.
NOTE:- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- Customizing with the Techstream
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Customize Setting / Light Control.
- Select the setting by referring to the table below.LIGHT CONTROL
Display Default Content Setting Relevant ECU Automatic High Beam On Enabling (on) or disabling (off) of the automatic high beam function On or Off Main Body ECU (Multiplex Network Body ECU)