On-Vehicle Inspection [10/2014 - ]: Procedure
- INSPECT REAR LIGHT ASSEMBLY LH
- Disconnect the O7 rear light assembly LH connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition O7-2 (B) - O7-4 (E) Light control switch off Below 1 V Light control switch in tail position 11 to 14 V O7-3 (B) - O7-4 (E) Power switch on (READY) and the shift lever not in R Below 1 V Power switch on (READY) and the shift lever in R 11 to 14 V TEXT IN ILLUSTRATION*a Front view of wire harness connector
(to Rear Light Assembly LH)If the result is not as specified, repair or replace the wire harness or connector.
- Disconnect the O7 rear light assembly LH connector.
- INSPECT REAR LIGHT ASSEMBLY RH
- Disconnect the O1 rear light assembly RH connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition O1-2 (B) - O1-4 (E) Light control switch off Below 1 V Light control switch in tail position 11 to 14 V O1-3 (B) - O1-4 (E) Power switch on (READY) and the shift lever not in R Below 1 V Power switch on (READY) and the shift lever in R 11 to 14 V TEXT IN ILLUSTRATION*a Front view of wire harness connector
(to Rear Light Assembly RH)If the result is not as specified, repair or replace the wire harness or connector.
- Disconnect the O1 rear light assembly RH connector.