On-Vehicle Inspection [10/2014 - ]: Procedure

INSPECT REAR COMBINATION LIGHT ASSEMBLY LH

Disconnect the O9 rear combination light assembly LH connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
O9-1 (STP) - O9-4 (E)	Brake pedal released	Below 1 V
O9-1 (STP) - O9-4 (E)	Brake pedal depressed	11 to 14 V
O9-2 (TL) - O9-4 (E)	Light control switch off	Below 1 V
O9-2 (TL) - O9-4 (E)	Light control switch in tail position	11 to 14 V
O9-3 (TRN) - O9-4 (E)	Turn signal switch in neutral position	Below 1 V
O9-3 (TRN) - O9-4 (E)	Power switch on (IG) and turn signal switch in left turn position	11 to 14 V (60 to 120 times per minute)

TEXT IN ILLUSTRATION

*a	Front view of wire harness connector (to Rear Combination Light Assembly LH)

If the result is not as specified, repair or replace the wire harness or connector.

INSPECT REAR COMBINATION LIGHT ASSEMBLY RH

Disconnect the O13 rear combination light assembly RH connector.

Measure the voltage according to the value(s) in the table below.

Standard Voltage

Tester Connection	Condition	Specified Condition
O13-1 (STP) - O13-4 (E)	Brake pedal released	Below 1 V
O13-1 (STP) - O13-4 (E)	Brake pedal depressed	11 to 14 V
O13-2 (TL) - O13-4 (E)	Light control switch off	Below 1 V
O13-2 (TL) - O13-4 (E)	Light control switch in tail position	11 to 14 V
O13-3 (TRN) - O13-4 (E)	Turn signal switch in neutral position	Below 1 V
O13-3 (TRN) - O13-4 (E)	Power switch on (IG) and turn signal switch in left turn position	11 to 14 V (60 to 120 times per minute)

TEXT IN ILLUSTRATION

*a	Front view of wire harness connector (to Rear Combination Light Assembly RH)

If the result is not as specified, repair or replace the wire harness or connector.