Inspection [10/2014 - 10/2015]: Procedure
- INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
LIGHT CONTROL SWITCHTester Connection Condition Specified Condition 18 (T) - 15 (EL) Light control switch DRL OFF 10 kΩ or higher 19 (H) - 15 (EL) 10 kΩ or higher 20 (A) - 15 (EL) 10 kΩ or higher 18 (T) - 15 (EL) Light control switch in tail position Below 1 Ω 18 (T) - 15 (EL) Light control switch in head position Below 1 Ω 19 (H) - 15 (EL) Below 1 Ω 20 (A) - 15 (EL) Light control switch in AUTO position Below 1 Ω DIMMER SWITCHTester Connection Condition Specified Condition 16 (HL) - 15 (EL) Dimmer switch in low position Below 1 Ω 14 (HU) - 15 (EL) 10 kΩ or higher 14 (HU) - 15 (EL) Dimmer switch in high position Below 1 Ω 14 (HU) - 15 (EL) Dimmer switch in high flash position Below 1 Ω 17 (HF) - 15 (EL) Below 1 Ω TURN SIGNAL SWITCHTester Connection Condition Specified Condition 12 (TR) - 15 (EL) Neutral 10 kΩ or higher 11 (TL) - 15 (EL) 10 kΩ or higher 13 (CR) - 15 (EL) 10 kΩ or higher 12 (TR) - 15 (EL) Right turn Below 1 Ω 13 (CR) - 15 (EL) Right turn fully Below 1 Ω 11 (TL) - 15 (EL) Left turn Below 1 Ω 13 (CR) - 15 (EL) Left turn fully Below 1 Ω FOG LIGHT SWITCH*1Tester Connection Condition Specified Condition 9 (BFG) - 8 (LFG) Fog light switch off 10 kΩ or higher 9 (BFG) - 8 (LFG) Fog light switch in front position Below 1 Ω - *1: w/ Front Fog Light
TEXT IN ILLUSTRATION*a Component without harness connected
(Headlight Dimmer Switch Assembly)If the result is not as specified, replace the headlight dimmer switch assembly.
- Measure the resistance according to the value(s) in the table below.