DTC B2452: Height Control Sensor Data Out of Range When Initializing [10/2014 - ]: Procedure
- PERFORM INITIALIZATION
- Perform initialization of the headlight leveling ECU assembly (Refer to INITIALIZATION [10/2014 - ]
).
HINT:
- Before initializing the headlight leveling ECU assembly, make sure that the vehicle condition is proper for initialization.
- Be sure to perform initialization as instructed.
Result:
NEXT
See step 2
- Perform initialization of the headlight leveling ECU assembly (Refer to INITIALIZATION [10/2014 - ]
).
- RECHECK FOR DTC
- Using the Techstream, recheck for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ]
).
OK
DTC B2452 is not output.
HINT:
If the headlight leveling ECU assembly stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU assembly.
Result:
OK
END
Result:
NG
REPLACE HEADLIGHT LEVELING ECU ASSEMBLY
(Refer to REMOVAL [10/2014 - ] )
- Using the Techstream, recheck for DTCs (Refer to DTC CHECK / CLEAR [10/2014 - ]
).