| Certification ECU Communication Stop Mode |
Either condition is met:
- "Certification (Smart)" is not displayed on the CAN Bus Check screen of the Techstream (Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ]
)
- Communication system DTCs (DTCs that start with U) that correspond to "Certification ECU Communication Stop Mode" in "DTC Combination Table" are output (Refer to DIAGNOSIS SYSTEM [10/2015 - ]
)
|
- Certification ECU (Smart key ECU assembly) branch line or connector
- Power source circuit of certification ECU (smart key ECU assembly)
- Certification ECU (Smart key ECU assembly) ground circuit
- Certification ECU (Smart key ECU assembly)
|