Open in One Side of Bus 2 Branch Line [10/2015 - ]: Procedure
- CHECK FOR OPEN IN ONE SIDE OF BUS 2 BRANCH LINE
- Based on the vehicle equipment and specifications, confirm the systems that use CAN communication.
Refer to DIAGNOSIS SYSTEM [10/2015 - ]
- Using the Techstream, select and perform the CAN bus check.
Refer to DIAGNOSIS SYSTEM [10/2015 - ]
- Observe the screen for approximately 2 minutes to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.
- Check the applicable communication stop mode for the ECU or sensor that is not displayed on the screen.
Result:
NEXT
GO TO CORRESPONDING COMMUNICATION STOP MODE. Refer to PROBLEM SYMPTOMS TABLE [10/2015 - ]
- Based on the vehicle equipment and specifications, confirm the systems that use CAN communication.