Installation [08/2014 - ]

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart. Refer to SPECIFIED TORQUE FOR STANDARD BOLTS [08/2014 - ] .

1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH 
   1. Temporarily install the upper control arm assembly and washer with the nut and bolt.
   2. Temporarily install the upper control arm assembly and washer to the rear axle housing with the nut and bolt.
2. INSTALL REAR WHEEL 

   for aluminum wheel 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

   for steel wheel 

   Torque: 112 N*m (1142 kgf*cm, 83 ft.*lbf) 

3. STABILIZE SUSPENSION  See step  3
4. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH 
   1. Tighten the 2 nuts.
      Fig 1: Identifying Upper Control Arm Assembly Replacement Components & Fasteners Location

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 80 N*m (816 kgf*cm, 59 ft.*lbf) 

      HINT: 

      Turn the nut while holding the bolt.