LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> 4Runner TRD Pro >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) - (Diagnostic Codes & Circuit Tests) >> Lighting System >> Circuit Tests >> Front Fog Light Circuit [08/2014 - ] >> Procedure

Front Fog Light Circuit [08/2014 - ]: Procedure

  1. PERFORM ACTIVE TEST USING TECHSTREAM (FRONT FOG LIGHT RELAY) 
    1. Using the Techstream, perform the Active Test. Refer to DATA LIST / ACTIVE TEST [08/2014 - ] .
      MAIN BODY

      Tester Display Test Part Control Range Diagnostic Note
      Front Fog Light Relay Front fog light relay ON/OFF -

      OK

      Front fog light relay operates (front fog lights come on).

    NG → See step   2 

    OK → See step   4 

  2. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) 
    1. Measure the voltage according to the value(s) in the table below.
      GTY213502Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Voltage

      Tester Connection Switch Condition Specified Condition
      2D-9 - Body ground Headlight dimmer switch in tail and front fog light switch on 11 to 14 V
      TEXT IN ILLUSTRATION

      *a Component with harness connected
      (Driver Side Junction Block Assembly)

    NG → See step   3 

    OK → REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - FOG LIGHT ASSEMBLY) 

  3. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [08/2014 - ] 
  4. REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [08/2014 - ]