Installation [08/2013 - ]

INSTALL COMBINATION METER ASSEMBLY
1. Connect the connector and temporarily install the combination meter assembly.
  NOTE:
  When installing the combination meter assembly, do not damage the upper instrument panel sub-assembly and combination meter assembly.
2. Install the combination meter assembly with the 4 screws.
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL
1. Engage the 11 clips and install the No. 1 instrument cluster finish panel.
2. Engage the 2 claws and 4 clips and install the instrument cluster finish panel.
INSTALL INSTRUMENT PANEL FINISH PANEL . Refer to INSTALLATION [08/2013 - ] - Step 36
INSTALL INSTRUMENT SIDE PANEL LH . Refer to INSTALLATION [08/2013 - ] - Step 23
INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 33
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 34
INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH . Refer to INSTALLATION [08/2013 - ] - Step 35
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
INSTALL STEERING WHEEL ASSEMBLY . Refer to INSTALLATION [08/2013 - ] - Step 12
INSTALL STEERING PAD . Refer to INSTALLATION [08/2013 - ] - Step 1
INSTALL LOWER NO. 3 STEERING WHEEL COVER . Refer to INSTALLATION [08/2013 - ] - Step 2
INSTALL LOWER NO. 2 STEERING WHEEL COVER . Refer to INSTALLATION [08/2013 - ] - Step 3
INSPECT STEERING WHEEL CENTER POINT
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .
INSPECT STEERING PAD . Refer to ON-VEHICLE INSPECTION [08/2013 - ] - Step 1
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [08/2013 - ]