Removal [12/2012 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [12/2012 - ] ).
- PLACE FRONT WHEELS FACING STRAIGHT AHEAD
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [12/2012 - 10/2015] , or refer to INITIALIZATION [10/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - ] ).
- REMOVE STEERING WHEEL ASSEMBLY
Refer to REMOVAL [12/2012 - 10/2015] , or refer to REMOVAL [10/2015 - ]
- REMOVE STEERING COLUMN COVER NOTE:
Failure to follow the correct removal procedure may damage the claws.
- REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
- REMOVE UPPER INSTRUMENT PANEL
Refer to REMOVAL [12/2012 - 10/2015] , or refer to REMOVAL [10/2015 - ]
- REMOVE NO. 1 LOWER INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to REMOVAL [12/2012 - ]
- REMOVE COLUMN HOLE COVER SILENCER SHEET
- DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
- REMOVE ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY
- Disconnect the 2 connectors and 3 clamps.
- Remove the bolt and disconnect the harness cable.
- Remove the bolt, 2 nuts and steering column assembly.NOTE:
- Do not release the tilt lever when the steering column assembly is not installed to the vehicle.
- Do not drop or strike the steering column assembly. If dropped or struck, replace it with a new one.
- Disconnect the 2 connectors and 3 clamps.
- REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
- Remove the bolt.NOTE:
Do not remove the No. 2 steering intermediate shaft assembly from the steering column assembly.
- Put matchmarks on the No. 2 steering intermediate shaft assembly and steering column assembly.
*a Matchmark - Remove the No. 2 steering intermediate shaft assembly from the steering column assembly.
- Remove the bolt.