Installation [12/2012 - ]: Procedure
- INSTALL OCCUPANT DETECTION ECU
- Attach the claw to install the occupant classification ECU.NOTE:
If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.
- Connect the 2 connectors.NOTE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.
- Attach the claw to install the occupant classification ECU.
- INSTALL FRONT SEAT ASSEMBLY RH
- for Manual Seat:
Refer to INSTALLATION [12/2012 - 08/2016] Refer to INSTALLATION [08/2016 - ]
- for Power Seat:
Refer to INSTALLATION [12/2012 - ]
- for Manual Seat:
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]
- ZERO POINT CALIBRATION AND SENSITIVITY
Refer to INITIALIZATION [12/2012 - ]
- PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [12/2012 - ]
- CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [12/2012 - ]